• 8S1P 25.6V3.3Ah LiFepo4 battery pack
  • 8S1P 25.6V3.3Ah LiFepo4 battery pack
  • 25.9V(7S)-33.3V(9S) - 8S1P 25.6V3.3Ah LiFepo4 battery pack
  • 25.9V(7S)-33.3V(9S) - 8S1P 25.6V3.3Ah LiFepo4 battery pack

8S1P 25.6V3.3Ah LiFepo4 battery pack

25.9V(7S)-33.3V(9S)

Model: AY-LF8S1P-26650-3300mAh
Voltage: 25.6V
Capacity: 3300mAh
Size (can be customized): L106.3* W63*T67mm
Cell Model: 26650-3300mAh

  • Description
  • Get quote
Sender email add: RE: 8S1P 25.6V3.3Ah LiFepo4 battery pack
  • 25.9V(7S)-33.3V(9S)

    AY-LF8S1P-26650-3300mAh

    8S1P 25.6V 3300mAh LiFepo4 battery pack 
    Technical Parameters
    Battery pack * 25.6V 3300mAh LiFepo4 Battery is made by 8pcs of 26650 3300mah lifepo4 cell
    * In 8S1P configuration
    * Wrap with heavy duty PVC
    Charge Information *Charge voltage: 28.8V±0.05V (3.6V/cell)
    *Charge method: CC/CV (Constant-current and-Voltage with Limited current)
    *Standard charging time: 3A/ 1.5hours, 1A/3.3hours
    (Battery capacity÷charging current×1.5 )
    *Charge current: 1A 
    Dishcharge Information * Maximum discharging current: 10A (3C)
    * Continuous discharge current: 10A (3C)
    * Discharge cut-off voltage: 16V (2.0V/cell)
    Protection Information * Protected by one PCM
    * PCM is installed in the battery pack to balance charging and protect battery
    * Must wait min of 30 minutes afrer battery is fully charged to allow the PCM to perform balance function on all the cells within the pack
    * Maximal continuous charging current: 10A
    * Maximal continuous discharging current: 10A
    * Over-charge& over-discharge detection voltage: 3.9V/2.0V
    * Over-current detection: 30A±5A
    Short-circuit Protection Exterior short circuit Automatic recovery
    Intermal resistance / Cycle life ≤200mΩ / ≥500
    Operating Temperature *Standard Charge: 0~+40℃ / *Standard Discharge: -20~+60℃
    Pre-wired * Red=Positive,Black=Negative
    Weight/Dimension around 0.9 kgs (including cells,pcm.pvc wires) ; L106.3* W63*T67mm
    Applications * Apply to Dynamic train model, Consumer Electronics, digital products.
    * Replace 24V lead acid battery with much clear engergy.
    Warnings * 25.6V 3300MAh LiFepo4 Battery should be cut-off at ≥16V (2.0V/cell) during
    discharging, and should be stop charging at ≤25.6V(4.2V/cell)during charging.
    * We are not responsible for an damages or losses caused by misuse (included but not
    limited to: Improper charging/discharging, any changes of this battery pack,
    miss-assembling battery packs.)
    * Always pay attention to when charging the battery pack. Battery shall put in a place
    or wrong polarity connection.
    * Please always check battery polarity before connection to device. Never make wrong polarity connection.

Copyright © 2017 AYAA TECHNOLOGY CO.,LTD. All Rights Reserved. Design By Gemelsoft.