• 1S1P 3.6V 2Ah Li-Polymer battery pak
  • 3.7V(1S)-11.1V(3S) - 1S1P 3.6V 2Ah Li-Polymer battery pak

1S1P 3.6V 2Ah Li-Polymer battery pak

3.7V(1S)-11.1V(3S)

Model: AY-LP1S1P-103450-2000mAh
Voltage: 3.6V
Capacity: 2Ah
Size (can be customized): L50* W34*T10mm
Cell Model: 103450-2000mAh

  • Description
  • Get quote
Sender email add: RE: 1S1P 3.6V 2Ah Li-Polymer battery pak
  • 3.7V(1S)-11.1V(3S)

    AY-LP1S1P-103450-2000mAh

    1S1P 3.6V 2Ah Li-Polymer Battery pack 
    Technical Parameters
    Battery pack * 3.6V 2Ah Li(NiCoMn)O2 Battery is made by 1pcs of
    Li(NiCoMn)O2 103450 2000mAh cells
    * In 1S1P configuration
    * Wrap with heavy duty PVC
    Charge Information *Charge voltage: 4.2V±0.05V (4.2V/cell)
    *Charge method: CC/CV (Constant-current and-Voltage with Limited current)
    *Standard charging time: 440mA/7 hours, 2A/1hours
    (Battery capacity÷charging current×1.5 )
    *Charge voltage: 4.2V (4.2V/cell)
    *Charge current: 0.44A
    Dishcharge Information * Maximum discharging current: 2A 
    * Continuous discharge current: 0.44A 
    * Discharge cut-off voltage: 2.8V (2.75V/cell)
    Protection Information * Protected by one PCM:
    * PCM is installed in the battery pack to balance charging and protect battery
    * Must wait min of 30 minutes afrer battery is fully charged to allow the PCM to perform balance function on all the cells within the pack
    * Maximal continuous charging current: 0.4A
    * Maximal continuous discharging current: 2A
    * Over-charge& over-discharge detection voltage: 4.25V/2.8V
    * Over-current detection: 6±2A
    Short-circuit Protection Exterior short circuit Automatic recovery
    Intermal resistance / Cycle life ≤100mΩ / ≥300
    Operating Temperature *Standard Charge: -20~+50℃ / *Standard Discharge: -20~+50℃
    Pre-wired * Red=Positive,Black=Negative
    Weight/Dimension around 0.04kgs(including cells,pcm.pvc wires) ;L50* W34*T10mm
    Applications * Apply to light, medical device, etc
    * Replace 3.6V Nimh battery and 4V lead acid battery with much clear engergy.
    Warnings * 3.6V 2Ah Li(NiCoMn)O2 Battery should be cut-off at ≥2.8V (2.75V/cell) during
    discharging, and should be stop charging at ≤ 4.25V during charging.
    * We are not responsible for an damages or losses caused by misuse (included but not
    limited to: Improper charging/discharging, any changes of this battery pack,
    miss-assembling battery packs.)
    * Always pay attention to when charging the battery pack. Battery shall put in a place
    or wrong polarity connection.
    * Please always check battery polarity before connection to device. Never make wrong polarity connection.

Copyright © 2017 AYAA TECHNOLOGY CO.,LTD. All Rights Reserved. Design By Gemelsoft.