• 3S9P 11.1V 23.4Ah Li-Polymer Battery pack
  • 3S9P 11.1V 23.4Ah Li-Polymer Battery pack
  • 3.7V(1S)-11.1V(3S) - 3S9P 11.1V 23.4Ah Li-Polymer Battery pack
  • 3.7V(1S)-11.1V(3S) - 3S9P 11.1V 23.4Ah Li-Polymer Battery pack

3S9P 11.1V 23.4Ah Li-Polymer Battery pack

3.7V(1S)-11.1V(3S)

Model: AY-LP3S9P-18650-2600mAh
Voltage: 11.1V
Capacity: 23.4Ah
Size (can be customized): L171* W75*T60mm
Cell Model: 18650-2600mAh

  • Description
  • Get quote
Sender email add: RE: 3S9P 11.1V 23.4Ah Li-Polymer Battery pack
  • 3.7V(1S)-11.1V(3S)

    AY-LP3S9P-18650-2600mAh

    3S9P 11.1V 23.4Ah Li-Polymer Battery pack
    Technical Parameters
    Battery pack * 11.1V 23.4Ah Li(NiCoMn)O2 Battery is made by 27pcs of
    Li(NiCoMn)O2 18650 2600mAh cells
    * In 3S9P configuration
    * Wrap with heavy duty PVC
    Charge Information *Charge voltage: 12.6V±0.05V (4.2V/cell)
    *Charge method: CC/CV (Constant-current and-Voltage with Limited current)
    *Standard charging time: 4680mA/ 7hours, 10A/3hours
    (Battery capacity÷charging current×1.5 )
    *Charge voltage: 12.6V (4.2V/cell)
    *Charge current: 4.68A
    Dishcharge Information * Maximum discharging current: 10A 
    * Continuous discharge current: 10A 
    * Discharge cut-off voltage: 8.1V (2.5V/cell)
    Protection Information * Protected by one PCM:
    * PCM is installed in the battery pack to balance charging and protect battery
    * Must wait min of 30 minutes afrer battery is fully charged to allow the PCM to perform balance function on all the cells within the pack
    * Maximal continuous charging current:10A
    * Maximal continuous discharging current: 10A
    * Over-charge& over-discharge detection voltage: 4.25V/2.5V
    * Over-current detection: 40±10A
    Short-circuit Protection Exterior short circuit Automatic recovery
    Intermal resistance / Cycle life ≤60mΩ / ≥300
    Operating Temperature *Standard Charge: -20~+50℃ / *Standard Discharge: -20~+50℃
    Pre-wired * Red=Positive,Black=Negative
    Weight/Dimension around 0.05kgs(including cells,pcm.pvc wires) ;L171* W75*T60mm
    Applications * Apply to light, medical device, etc
    * Replace 12V Nimh battery and 12V lead acid battery with much clear engergy.
    Warnings * 11.1V 23.4Ah Li(NiCoMn)O2 Battery should be cut-off at ≥8.1V (2.5V/cell) during
    discharging, and should be stop charging at ≤12.75 V during charging.
    * We are not responsible for an damages or losses caused by misuse (included but not
    limited to: Improper charging/discharging, any changes of this battery pack,
    miss-assembling battery packs.)
    * Always pay attention to when charging the battery pack. Battery shall put in a place
    or wrong polarity connection.
    * Please always check battery polarity before connection to device. Never make wrong polarity connection.

Copyright © 2017 AYAA TECHNOLOGY CO.,LTD. All Rights Reserved. Design By Gemelsoft.