• AY-L10S10P-18650-29E
  • AY-L10S10P-18650-29E
  • 36V(10S)-44.4V(12S) - AY-L10S10P-18650-29E
  • 36V(10S)-44.4V(12S) - AY-L10S10P-18650-29E



Model: AY-L10S10P-18650-29E
Voltage: 37V
Capacity: 28500mAh
Size (can be customized): L380.5X W98.5X T67mm
Cell Model: Samsung 1865029E 2850mah

  • Description
  • Get quote
Sender email add: RE: AY-L10S10P-18650-29E
  • 36V(10S)-44.4V(12S)


    10S10P 37V 28500mAh Li-ion battery pack 
    Technical Parameters
    Battery pack * 37V 28500mAh Li(NiCoMn)O2 Battery is made by 100 pcs of
    Li(NiCoMn)O2 18650 2850mAh cells
    * In 10S10P configuration
    * Wrap with heavy duty PVC
    Charge Information *Charge voltage: 54.6V±0.05V (4.2V/cell)
    *Charge method: CC/CV (Constant-current and-Voltage with Limited current)
    *Standard charging time: 5700mA/ 5hours,10000mA/3hours
    (Battery capacity÷charging current×1.5 )
    *Charge current: 25A 
    Dishcharge Information * Maximum discharging current: 25A 
    * Continuous discharge current: 25A 
    * Discharge cut-off voltage: 25V (2.5V/cell)
    Protection Information * Protected by one PCM:
    * PCM is installed in the battery pack to balance charging and protect battery
    * Must wait min of 30 minutes afrer battery is fully charged to allow the PCM to perform balance function on all the cells within the pack
    * Maximal continuous charging current: 25A
    * Maximal continuous discharging current: 25A
    * Over-charge& over-discharge detection voltage: 4.25V/2.5V
    * Over-current detection: 80A±10A
    Short-circuit Protection Exterior short circuit Automatic recovery
    Intermal resistance / Cycle life ≤200mΩ / ≥500
    Operating Temperature *Standard Charge: 0~+40℃ / *Standard Discharge: -20~+60℃
    Pre-wired * Red=Positive,Black=Negative
    Weight/Dimension around 7.0kgs(including cells,pcm.pvc wires) ; L380.5X W98.5X T67mm
    Applications * Apply to e-bike, e-scooter , three-wheeler rickshaw
    * Replace 42V Nimh battery and 42V lead acid battery with much clear engergy.
    Warnings * 37V 28500MAh Li(NiCoMn)O2 Battery should be cut-off at ≥25V (2.5V/cell) during
    discharging, and should be stop charging at ≤42V(4.2V/cell)during charging.
    * We are not responsible for an damages or losses caused by misuse (included but not
    limited to: Improper charging/discharging, any changes of this battery pack,
    miss-assembling battery packs.)
    * Always pay attention to when charging the battery pack. Battery shall put in a place
    or wrong polarity connection.
    * Please always check battery polarity before connection to device. Never make wrong polarity connection.

Copyright © 2017 AYAA TECHNOLOGY CO.,LTD. All Rights Reserved. Design By Gemelsoft.