• 1S2P 3.7V 20Ah Li-polymer battery pack
  • 1S2P 3.7V 20Ah Li-polymer battery pack
  • 1S2P 3.7V 20Ah Li-polymer battery pack
  • 5001mAH-20000mAH - 1S2P 3.7V 20Ah Li-polymer battery pack
  • 5001mAH-20000mAH - 1S2P 3.7V 20Ah Li-polymer battery pack
  • 5001mAH-20000mAH - 1S2P 3.7V 20Ah Li-polymer battery pack

1S2P 3.7V 20Ah Li-polymer battery pack

5001mAH-20000mAH

Model: AY-LP1S2P-9059156-10Ah
Voltage: 3.7V
Capacity: 20Ah
Size (can be customized): L167* W61*T19mm
Cell Model: 9059156-10Ah

  • Description
  • Get quote
Sender email add: RE: 1S2P 3.7V 20Ah Li-polymer battery pack
  • 5001mAH-20000mAH

    AY-LP1S2P-9059156-10Ah

    1S2P 3.7V 20Ah Li-polymer battery pack 
    Technical Parameters
    Battery pack * 3.7V 20Ah Li-polymer Battery is made by 2pcs of
    li-polymer 9059156 10Ah cells
    * In 1S2P configuration
    * Wrap with heavy duty PVC
    Charge Information *Charge voltage: 4.2V±0.05V (4.2V/cell)
    *Charge method: CC/CV (Constant-current and-Voltage with Limited current)
    *Standard charging time: 5A/ 6hours
    (Battery capacity÷charging current×1.5 )
    *Charge current: 5A 
    Dishcharge Information * Maximum discharging current: 5A 
    * Continuous discharge current: 5A 
    * Discharge cut-off voltage: 2.5V (2.5V/cell)
    Protection Information * Protected by one PCM:
    * PCM is installed in the battery pack to balance charging and protect battery
    * Must wait min of 30 minutes afrer battery is fully charged to allow the PCM to perform balance function on all the cells within the pack
    * Maximal continuous charging current: 5A
    * Maximal continuous discharging current: 5A
    * Over-charge& over-discharge detection voltage: 4.325V/2.5V
    * Over-current detection: 9A±2A
    Short-circuit Protection Exterior short circuit Automatic recovery
    Intermal resistance / Cycle life ≤200mΩ / ≥500
    Operating Temperature *Standard Charge: 0~+40℃ / *Standard Discharge: -20~+60℃
    Pre-wired * Red=Positive,Black=Negative
    Weight/Dimension around 0.38kgs(including cells,pcm.pvc wires) ; L167* W61*T19mm
    Applications * Apply to GPS device, medical devices, etc
    * Replace 3.6V Nimh battery with much clear engergy.
    Warnings * 3.7V 20Ah Li-polymer Battery should be cut-off at ≥2.5V (2.5V/cell) during
    discharging, and should be stop charging at ≤4.2V(4.2V/cell)during charging.
    * We are not responsible for an damages or losses caused by misuse (included but not
    limited to: Improper charging/discharging, any changes of this battery pack,
    miss-assembling battery packs.)
    * Always pay attention to when charging the battery pack. Battery shall put in a place
    or wrong polarity connection.
    * Please always check battery polarity before connection to device. Never make wrong polarity connection.

Copyright © 2017 AYAA TECHNOLOGY CO.,LTD. All Rights Reserved. Design By Gemelsoft.