LED Fuel Gauge PCM-LED005-339
Smart Battery Managment with Fuel Guage
| Model: | PCM-LED005-339 |
|---|---|
| Working current: | 80uA |
| Size: | L51*W26*T4 mm |
| Balancing: | no |
| Temp. control: | |
| Battery Type: | |
| Battery Series: | 1-12S |
| Continuous Current: |
| Model: | PCM-LED005-339 |
|---|---|
| Working current: | 80uA |
| Size: | L51*W26*T4 mm |
| Balancing: | no |
| Temp. control: | |
| Battery Type: | |
| Battery Series: | 1-12S |
| Continuous Current: |
| Features： | Specification： |
| ·Apply for PCB of 1～12 cells Li-ion /Li-polymer battery pack. | ·Power consumption:80uA |
| ·No external power is need | ·Dimension(LxWxH)：L51×W26×H4mm |
| ·Can connect directly to pcb/pcm via special connector on | ·Weight： 6.5g |
| board or connect directly to output of battery pack | |
| • 5 LED display for battery pack's voltage.The voltage listed below | Warning： |
| is base on battery during discharge.(The actual voltage might | ＊ Please do not plug in wrong polarity |
| vary for LED 2-4 during charging.) | otherwise the module will be completely destroyed. |
| 0%LED Flashing for singel cell voltage<3V(must recharge battery) | ＊ The resistance potential ratio of energy display |
| 1 LED = 20% for singel cell voltage: 3.0-3.3V（battery need recharging） | module in different packs are different, |
| 2 LED = 40% for singel cell voltage: 3.3-3.5V | only use the voltage that the label nominated. |
| 3 LED = 60% for singel cell voltage: 3.5-3.8V | ＊ Please make sure your selection is correct before you buy. |
| 4 LED = 80% for singel cell voltage: 3.8-4.1V | |
| 5 LED = 100% for singel cell voltage: 4.1-4.2V ( battery is full ) | |
| Resistance potential ration in different numbers | |
Copyright © 2017 AYAA TECHNOLOGY CO.,LTD. All Rights Reserved. Design By Gemelsoft.
